KEEP OUT OF REACH OF CHILDREN AND PETS

CAUTION: MAY CAUSE EYE IRRITATION. CONTENTS UNDER PRESSURE.

DO NOT spray towards face. Avoid contact with eyes and skin.

CONTAINER MAY EXPLODE IF HEATED. DO NOT puncture or incinerate container. DO NOT expose to heat or store at temperatures above 120 °F, as the container may burst.

FIRST AID:

If in eyes, IMMEDIATELY rinse eyes with plenty of water. Remove contact lenses and continue to rinse for at least 15 minutes. If irritation persists, get medical attention. When using RESOLVE® EASY CLEAN PRO, direct aerosol away from face when loading the device and replacing the spray cap to can.

CONTAINS NO PHOSPHORUS.

Store in a cool, dry place in areas inaccessible to small children and pets.

Please recycle when finished. If recycling is not available in your area, discard empty container in trash. If container is partially filled, call your local solid waste agency for disposal directions.

HOW TO USE:

1. Shake well & spray
2. Work in the foam using a brush or damp, colorfast mop
3. Leave for 2 hours, or until dry, then vacuum

RESOLVE® PET EXPERT STAIN & ODOR REMOVER FOAM Carpet Cleaner is safe to use on wool, nylon and stain-resistant carpet.

BEFORE CLEANING: Vacuum carpet thoroughly to remove loose dirt. Test a small, hidden area for colorfastness and examine when dry. If color is affected do not use. For upholstery, look for manufacturer’s cleanability code tag. Use on fabrics coded “WS” or “W”. If coded “X” or “S”, do not use. Not recommended for use on velvet, silk, vinyl, or leather. DO NOT use RESOLVE® EASY CLEAN PRO on any surface other than carpets.

***DO NOT spray directly on pets. Use only in well ventilated areas. Keep children and pets off carpet till dry.

DIRECTIONS: • LARGE AREA CARPET CLEANING:

1. SHAKE CAN WELL. Hold can upside down about 2 feet above carpet. Spray foam evenly over a 3 foot square area.
2. Work the foam into carpet in two directions using a damp, colorfast mop.
3. Repeat steps 1 & 2 until the entire area is cleaned.
4. When dry, vacuum thoroughly to remove dried foam and loosened dirt.

• FOR USE IN RESOLVE® EASY CLEAN PRO:

1. Remove spray cap from RESOLVE® High Traffic Foam 22oz can. SHAKE THE CAN VIGOROUSLY BEFORE EACH USE. If the can is already in the gadget, remove and shake again.
2. Insert can into the gadget and rotate clockwise until it gently clicks into the locked position.
3. To remove the can, rotate counter-clockwise into the unlocked position and gently pull upwards.
4. Pull trigger to dispense foam, then brush the foam into the carpet. When dry, vacuum thoroughly to remove dried foam and loosened dirt.
5. Replace spray cap to can for standard use.

• UPHOLSTERY CLEANING:

1. Blot wet soils with a clean absorbent cloth.
2. SHAKE CAN WELL and generously apply directly to stain from a distance of 4-6 inches. Allow foam to absorb into stain for 3 minutes.
3. Gently blot area with a clean, damp, colorfast sponge or cloth. Rub gently if required. DO NOT OVERWET FABRICS. Hint: To avoid rings, clean entire section where soil occurs.
4. Rinse sponge or cloth and repeat as necessary. Allow fabric to dry thoroughly before use.
5. ONLY use spray cap to dispense foam for upholstery cleaning.

To ensure complete dispensing during life of product, tilt can downwards at approximately 60° while spraying. Contents will clean a carpeted area of 168 square feet (12' x 14'). If accidentally sprayed on wood furniture, just wipe off.

FOR BEST RESULTS: Use vacuum cleaner with a fresh, empty bag.